190gsm spandex single jersey

  190gsm 58%cotton 38% polyester 4% spandex single jersey 

Dear friends, hope that all of you are fine today. Today I am going to discuss lycra single jersey fabrics. Basically, lycra single jersey fabrics need to heat set process for full feeder fabric. Actually this need to fix the spandex in a certain width and gsm. It also helps to remove crease marks from fabric. In our factory, we make various types of lycra single jersey fabrics. The fabric quality of lycra single jersey fabrics depends on lycra yarn and cotton or viscose yarn quality. If we use combed yarn or compact yarn then we get good-quality fabric. We always get good quality Invista brand spandex. We have done some fabrics and got better recovery and elongation by Invista spandex than other brands. In this blog, I am going to discuss a CVC lycra single jersey fabric. 

Required gsm: 190 

Required yarn: 32/1 cvc60/40+ 20D spandex 

Required Dia : 72 inch 

Fabric color: Pink 

Stitch length: 3.00

Machine dia x gauge: 36x24 

As this is a spandex full feeder fabric so we need to heat set the fabric.

Heat set parameter: 

Heat set is a very important process for textile processing.

Before heat set dia: 70 inch 

Before heat set gsm: 214 

Width set:75 inch 

Overfeed%: 28%

Temperature: 200°c

Speed: 20 meter/minute

After heat set dia: 76 inch 

After heat set gsm: 185 

After that, we dye the fabric in stenter machine again. 

Width set: 186 cm 

Overfeed%: 22℅

Speed: 28 meter / minute

Temperature: 160°C 

Blower:  85%

Padder pressure: 35/25 

Softener use: yes

After stenter dia: 74 inch 

After stenter gsm: 175

After that, we process this fabric in a complex machine.  

Temperature: 110°C 

Speed: 18 meter/minute 

Overfeed%: 40%

Steam: full 

Compacting %: -5%

After compacting dia: 73 inch 

After compacting gsm: 180-191 

Shrinkage: 

Lengthwise %: -1.83%

Widthwise %: -2.5%

Spirality:1%